Cutlass Ciera Cruiser V6-3300 3.3L (1989)
12.
Assemble the cooling fan to the motor and fan and motor assembly to the bracket, as shown in Figure 2.
13.
Install the cooling fan assembly, as shown in Figure 2.
14.
Route the motor harness along the RH outboard leg of the bracket and secure in place with the two other adjustable plastic retainers. Cut off excess
ends of retainer.
15.
Attach the jumper wiring harness to the fan motor harness and route jumper harness through the front end panel.
16.
Install the remaining plastic push-in retainer to the RH side air baffle and condenser.
17.
Install the new relay in the relay mounting bracket on the RH side of front end panel, as shown in Figure 2.
18.
Splice the red # 2F wire from cavity A of the new relay connector to the red # 2A wire in cavity A of the existing cooling fan relay connector.
Cover the splice with the heat shrink tubing that is taped to the wire.
