Cutlass Ciera Cruiser V6-3300 3.3L (1989)
1.
Negative battery cable.
2.
Serpentine belt.
3.
Raise car and suitably support, see Section OA.
4.
Right front wheel and tire assembly.
5.
Inner fender splash shield (right side).
6.
Torque converter cover.
7.
Hold flywheel with J 37096.
8.
Balancer bolt.
9.
Crankshaft balancer.
Important:
The balancer is serviced as an assembly. Do not attempt to separate pulley from balancer hub.
Install or Connect:
1.
Crankshaft balancer.
^
Lubricate seal surface with engine oil.
2.
Balancer bolt and washer.
^
Hold flywheel with J 37096.
^
Balancer bolt to 140 N-m (103 lbs.ft.).
-
Loosen bolt to finger tight.
-
Utilizing tool J 36660, retorque to 150 N-m (110 lbs.ft.) plus 56 degrees.
3.
Inner fender splash shield.
4.
Right front wheel and tire assembly.
5.
Torque converter cover.
6.
Lower car.
7.
Serpentine belt.
8.
Negative battery cable.
NOTE:
After installation of either of the hose assemblies and/or pump, it is essential that the system be properly bled following the procedure in Section
3B1 of the 1991 service manual.
WARRANTY INFORMATION:
Use appropriate Labor Operation Number and Time. Additional labor time to complete the repair should be submitted as required in straight time.
