Cutlass Ciera FWD L4-151 2.5L (1982)
FIGURE 2
1.
Change wire location in connector as shown in Figure 2.
2.
Besure to insert plastic plug into cavity "D" as shown in Figure 2. (A package of plastic plugs has been included with this bulletin in the event they
are needed.)
3.
Install new relay using the two retainers removed from the old relay.
4.
Snap connector into relay. Be sure connector seats properly.
5.
Reconnect negative battery cable.
Part II - Cooling Fan Operation Should be Checked After Installation of the New Relay Using the Following Procedure:
1.
Engine should be cool enough that engine cooling fan is not running. (Engine cooling fan will operate if the engine temperature switch senses
coolant at or above 110~ C. (230~ F.).
2.
Ground under-dash diagnostic connector by jumping TEST terminal B to GROUND terminal A.
3.
Turn ignition switch to "ON" position only. DO NOT START ENGINE.
4.
Operate the air control (upper) lever of the A/C control. Engine cooling fan should be operating when lever is in the A/C positions of "MAX,"
