Cutlass Ciera FWD L4-151 2.5L (1982)
7. Remove screws and lockwashers, then remove fuel meter body from throttle body assembly, Fig. 173.
8. Remove insulator gasket from fuel meter body.
9. Position throttle body on a clean, flat surface.
Fig. 174 Removing throttle position sensor. (typical)
10. Remove TPS attaching screws, lockwashers, and retainers. Remove TPS sensor from the throttle body, Fig. 174. Discard and replace screws.
11. Remove screw holding TPS actuator lever to end of throttle shaft.
12. Remove IAC assembly and gasket from the throttle body.
NOTE: On 1982 models spot welds on bottom of TBI unit must be drilled out before removing the TPS.
