Cutlass Ciera FWD L4-151 2.5L (1982)
FIGURE 6
X
10. Inspect the turbine shaft seal grooves. A step in the bottom
corners of the seal groove will keep the seal from contacting the side wall of the groove and will prevent proper
sealing. See Fig. 6. If this condition is found, replace the turbine shaft and seals.
FIGURE 7 - CASE COVER - VALVE BODY SIDE
X
11. Check the case cover sleeve converter feed oil hole for
being out of alignment with the oil channel in the case cover. See Fig. 7. Inspect gasket pattern for leakage at converter apply passage. If
gasket contact pattern is not complete, replace case cover.
X
12. Check the converter end play, using tool J-29830A. The
