Cutlass Ciera FWD V6-260 4.3L DSL (1982)
1. Remove pump cover.
2. Remove terminal contact nuts, then remove solenoid from cover noting position of any insulating washers.
3. Place solenoid in cover ensuring that shut-off solenoid linkage is free. Also, check that housing pressure cold advance solenoid plunger is centered
so that it will contact fitting check ball, Fig. 43.
4. Place insulator washers on terminal studs and install terminal nuts. Torque nuts to 10-15 inch lbs. and replace pump cover.
Housing Pressure Cold Advance Solenoid, Replace
Fig. 59 Exploded view of CAV pump
1. Remove governor control cover, see "Governor Control Cover Gasket, Replace."
2. Remove solenoid terminal nut, spring filter, insulating washers and solenoid, Fig. 59. Discard gasket.
3. Reverse procedure to install. Torque terminal nut to 20 in. lbs. and ensure solenoid is centered in cover.
Injection Pump Replace
