Cutlass Cruiser V8-260 4.3L VIN 8 2-bbl (1982)
Headlamp Switch: Service and Repair
Fig. 3 Headlight switch. Cutlass
CUTLASS
1.
Disconnect battery ground cable.
2.
Remove cluster pad assembly.
3.
Remove two headlight switch mounting screws, then pull switch away from panel adapter.
4.
To disconnect wire connector, pry connector at locations indicated by arrows as shown in Fig. 3. Pull connector out, then slide to left and push
forward to remove.
5.
Reverse procedure to install. Refer to Fig. 3, to install wire connector.
