Cutlass Cruiser V8-307 5.0L VIN Y 4-bbl (1983)
Manifold Pressure/Vacuum Sensor: Testing and Inspection
Component Diagnostic Charts - C3 System
Chart C-1D MAP and BARO Output Check
Fig. 008 - Chart C-1D Map and Baro Output Check
1. This checks the sensor voltage, which is highest when manifold pressure is highest. Output normally is in the middle range for specific altitudes.
Low voltage increases spark advance. High voltage decreases spark advance. MAP and BARO sensors are essentially the same device. One
measures pressure in the manifold and the other the pressure of the atmosphere.
2. This checks to see if the rate of change of the output vs. change in pressure is correct. Again, the normal change would be about the middle of the
