Cutlass Supreme V6-204 3.4L DOHC VIN X SFI (1995)
6.
Install I/P lower compartment access hole cover. This can be done by applying hand pressure to the foam on the cover and slowly compress flat
and hold. The foam will retain a flat shape long enough to be installed the first time it is crushed. If more attempts are made, the foam will recover
faster making it more difficult to install. With the cloth side of the cover facing the passenger compartment, align the cut out to the right upper
corner of the I/P lower compartment opening (Figure 4). Insert the foam and cloth edge between top forward edge of I/P lower compartment
opening and hinge pillar tie bar (Figure 3) while pushing rearward in vehicle. Position far enough rearward to capture foam on other side of
passenger side SIR module.
7.
Re-install two screws at top corners of lower compartment opening (Figure 4).
8.
Re-install I/P lower compartment assembly with access hole cover hanging down inside lower compartment.
9.
Insert access hole cover attachments two (2) from inside lower compartment into previously drilled holes. Once installed, close and cycle I/P lower
compartment. The access hole cover will be pulled forward and adjust to the opening.
Parts Information
Description
P/N
I/P Lower Hole Cover Access
10288630
Blower Motor Assembly
52473135
Parts are expected to be available on September 23, 1996 from GMSPO.
Warranty Information
For vehicles repaired under warranty, use:
Labor
Operation
Description
Labor Time
R&R Blower Motor
Use published
