Cutlass Supreme V6-204 3.4L DOHC VIN X SFI (1995)
NOTE: Rotate pulley assembly into belt a maximum of 15 Nm to allow engagement of the actuator shaft into the pulley arm socket.
8.
Pull the lock pin and discard. Retorque pulley assembly 15 Nm counterclockwise to seat pulley into belt.
Tighten: Both right hand (rear bank) camshaft sprocket bolts to 130 Nm (96 lb ft).
9.
Remove J-38613-A from right hand (rear bank) camshaft carrier.
10.
Rotate crankshaft 360 degrees clockwise while looking at front of engine and align crankshaft reference marks.
Inspect: Make sure both right hand (rear bank) camshaft flats are down.
Tighten: Both left hand (front bank) camshaft sprocket bolts to 130 Nm (96 lb ft).
11.
Remove J-38613-A from left hand (front bank) camshaft carrier.
12.
Rotate crankshaft 720 degrees clockwise while looking at front of engine to seat timing belt and verify correct timing.
Inspect: Make sure both camshaft flatspots are up on one bank and down on the opposing bank.
13.
Camshaft carrier covers and bolts and tighten to 11 Nm (97 lb In).
14.
Breather hose from rear camshaft cover and crankcase vent from breather manifold.
15.
Timing belt covers and bolts and tighten to 10 Nm (89 lb in).
16.
Fuel line bracket and bolt and tighten to 7 Nm (62 lb In).
17.
Wiring harness cover at right strut tower.
18.
Spark plug wires.
19.
PCM electrical connectors.
20.
Power steering lines to pump.
21.
Serpentine belt.
22.
Serpentine belt tensioner and tighten bolt to 45 Nm (33 lb ft).
23.
Coolant recovery tank.
24.
Upper intake manifold, bolts, and nuts and tighten bolts and nuts to 27 Nm (22 lb ft).
25.
Power brake vacuum hose.
26.
Wiring loom bracket for rear spark plug wires.
27.
Vacuum lines to upper intake manifold tee.
28.
Electrical connections to canister purge solenoid and MAP sensor.
29.
EGR valve and bolts, tighten to 25 Nm (18 lb ft).
30.
Electrical connectors from EGR.
31.
PCV valve and vacuum line to throttle body.
32.
Heater hose and bracket to lower intake manifold.
33.
Fuel mounting bracket and bolt.
34.
Fuel lines to fuel rail and install fuel rail cover.
35.
Accelerator and cruise control cables to throttle-body.
36.
Air cleaner assembly.
37.
Refill cooling and power steering systems.
38.
Negative battery cable.
