Cutlass Supreme V6-204 3.4L DOHC VIN X SFI (1995)
4. Right tie rod nut and tie rod.
5. Tighten right side engine splash shield.
6. Right front wheel and tire assembly.
7. Lower vehicle.
8. Return pipe to reservoir hose, tighten clamp.
9. High pressure pipe to pump.
10. Power steering lines clamp to front cover.
11. Serpentine drive belt.
12. Coolant recovery reservoir.
Adjust
^
Bleed power steering system.
Inspect
^
For leaks.
Cooler to Return Pipe Hose
Remove or Disconnect
1. Raise vehicle and suitably support.
2. Right front wheel and tire assembly.
3. Loosen right side engine splash shield.
4. Exhaust pipe and catalytic converter assembly.
5. Steering gear heat shield and screws.
6. Right tie rod nut and tie rod from steering knuckle.
7. Cut and remove hose clamps retaining hose.
8. Hose.
Install or Connect
1. Return hose and clamps.
2. Tighten clamps.
3. Tie rod and nut to steering knuckle.
4. Steering gear heat shield and screws.
Tighten
^
Screws to 6 N.m (54 lb. in.).
5. Exhaust pipe and converter.
6. Tighten right side engine splash shield.
7. Right front wheel and tire assembly.
8. Lower vehicle.
Adjust
^
Bleed power steering system.
Inspect
^
For leaks.
Cooler Pipe
