oldsmobile Workshop Repair Guides

Oldsmobile Workshop Service and Repair Manuals

Return Pipe|Page 1891 > < Return Pipe|Page 1889
Page 6
background image

13. Electrical connection from steering gear pressure switch.
14. Support rear of frame assembly using jackstand.
15. Both rear frame bolts.
16. Lower rear of frame 76.2 mm (3 inches).
17. Steering gear heat shield and heat shield screws.
18. Power steering lines clamp from steering gear assembly.
19. Both high pressure and return lines from steering gear.
20. High pressure line from vehicle.

Install or Connect

1. High pressure line in position.
2. Both high pressure and return lines to steering gear.
3. Line clamp and lines to steering gear assembly.
4. Steering gear heat shield and screws.

Tighten
^

Screws to 6 N.m (54 lb. in.).

5. Raise frame assembly and align steering gear stub shaft to intermediate shaft.
6. Both frame bolts.
7. Remove jackstand.
8. Electrical connection to steering gear pressure switch.

CAUTION: When installing the intermediate shaft make sure the shaft is seated prior to pinch bolt installation. If the pinch bolt is
inserted into the coupling before shaft installation, the two mating shafts may disengage.

NOTICE:  Set steering shaft so block tooth on upper steering shaft is at the 12 o'clock position, wheels on vehicle are straight ahead and set
ignition switch to "LOCK" position. Failure to follow these procedures could result in damage to the coil assembly.

9. Intermediate shaft lower pinch bolt.

Tighten
^

Bolt to 47 N.m (35 lb. ft.).

10. Exhaust pipe and converter assembly.
11. Both tie rod ends and nuts to steering knuckles.
12. Tighten right side engine splash shield.
13. Both right and left front wheel and tire
14. Lower vehicle.
15. Remove J 28467-A, J 28467-90 and J 36462.
16. Power steering lines clamp to front cover.

Tighten
^

Bolt to 25 N.m (18 lb. in.)

17. Both high pressure and return pipes to pump.
18. Serpentine drive belt.
19. Coolant recovery reservoir.
20. Air cleaner and duct assembly.
21. Fill system.

Adjust
^

Bleed power steering system.

Inspect
^

For leaks.

Fluid Cooling Pipe Assembly/Reservoir Inlet Hose (Return Line)

Return Pipe|Page 1891 > < Return Pipe|Page 1889