Cutlass Supreme V6-204 3.4L DOHC VIN X SFI (1995)
2. Install insulator clips.
3. Quick-connect fittings at fuel sender.
4. Chassis to sender fuel pipe assemblies.
5. Position EVAP pipe on insulator clips as noted during disassembly.
6. Install retaining clip on EVAP pipe.
7. Install fuel sender assembly.
INSTALL OR CONNECT
1. With the aid of an assistant, position and support fuel tank. Position fuel tank straps, loosely install fuel tank strap attaching bolts and connect:
A. EVAP hose to vapor pipe (at rear of tank).
B. EVAP hose to fuel sender assembly.
C. Fuel sender electrical connector and install retaining clips.
D. Rear fuel tank strap attaching bolts.
Tighten
Front and rear fuel tank strap attaching bolts to 47 Nm (35 lb. ft.).
WARNING:
To Reduce the Risk of Fire and Personal Injury: Before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the
male tube ends. This will ensure proper reconnection and prevent a possible fuel leak. (During normal operation, the O-rings located in
the female connector will swell and may prevent proper reconnection if not lubricated.)
2. Quick-connect fittings.
3. EVAP hose to EVAP pipe (at front of fuel tank).
4. Fuel filler EVAP hose to fuel tank.
5. Fuel filler hose to fuel tank.
6. Heat shield attaching screws and heat shield.
7. Rubber exhaust pipe hangers.
8. Lower vehicle.
9. Add fuel and install fuel filler cap.
10. Negative battery cable.
INSPECT
Turn ignition switch to "ON," position for two seconds, then turn to "OFF" for ten seconds. Again turn to "ON" position, and check for fuel leaks.
