Cutlass Supreme V6-204 3.4L DOHC VIN X SFI (1995)
-
Fuel pump inlet for dirt and debris. If found, fuel pump should be replaced.
FUEL SENDER
1. Transfer fuel pump and fuel pulse dampener to new fuel sender.
ASSEMBLE
1. Fuel pulse dampener in same position as noted during disassembly.
2. Rubber bumper and rubber insulator on fuel pump.
3. Position fuel sender assembly upside down.
-
Install fuel pump between fuel pulse dampener and mounting bracket.
4. Fuel pump electrical connector.
NOTICE: Always install a new pump strainer when installing fuel pump.
5. New fuel pump strainer on fuel pump and push on outer edge of ferrule until fully seated.
INSTALL OR CONNECT
1. Fuel sender assembly.
2. Fuel tank.
3. Add fuel and install fuel filler cap.
4. Negative battery cable.
INSPECT
Turn ignition switch to "ON," position for two seconds, then turn to "OFF" for ten seconds. Again turn to "ON" position, and check for fuel leaks.
