Cutlass Supreme V6-204 3.4L DOHC VIN X SFI (1995)
Alarm Module: Service and Repair
PROGRAMMING A NEW DECODER MODULE
Key Code And Resistance Chart
New decoder modules are unprogrammed. Before the system will function properly after a new module has been installed, it must be programmed to the
code that matches the customer's keys. Programming a new module is very simple:
1. Install the new, unprogrammed decoder module.
2. Insert one of the customer's keys in the ignition lock cylinder and turn it to the "ON" position. It's a good idea to start the engine at this time to
verify system operation.
3. Observe the "SECURITY" Indicator Lamp:
^
The indicator lamp should light for about 5 seconds and then go out. If the wiring or contacts to the Key Resistance Pellet or the key is
defective or intermittent and a new module is installed, the Engine will start but the "SECURITY" Indicator will flash at a rate of one flash per
second until the Ignition Switch is turned off. This indicates that the module did not program and that the system components, wiring and
contacts should be checked for a fault.
IMPORTANT: Before connecting the Interrogator to the ignition lock cylinder circuit, always verify vehicle key code and set the code into
the Interrogator using "key code" knob. This will prevent programming an unprogrammed decoder module with an undesired key code.
