Cutlass Supreme V6-204 3.4L DOHC VIN X SFI (1995)
7b. Tighten Lower bolt/screw to 50 Nm (37 lb. ft.).
8. Steering gear heat shield assembly.
9. Raise cradle and install rear cradle bolts.
10. Remove jacking fixture.
11. Intermediate shaft lower pinch bolt to steering gear.
12. Generator rear brace, bolt and nut.
^
Parts should fit easily. Tightening bolts and nuts MUST NOT put generator assembly in a bind.
Tighten
^
Generator rear brace nut to 50 Nm (37 ft lb).
^
Generator rear brace bolt to 25 Nm (18 ft lb).
13. Position generator cooling duct, if equipped. Refer to "Generator Cooling Duct".
14. Generator cooling duct bracket tab to oil pan, if equipped.
15. Front exhaust pipe heat shield.
16. Front exhaust pipe and converter assembly.
17. Right engine splash shield using upper retaining clips.
18. Right tire and wheel assembly.
19. Lower vehicle.
20. Generator upper stud and nut. Tighten Nut to 25 Nm (18 ft lb).
21. Power steering gear pipes to clip mounted on generator upper stud.
22. Serpentine drive belt.
23. Coolant recovery tank.
24. Battery negative cable assembly at battery. Tighten Cable bolt to 15 Nm (11 ft lb).
25. Air cleaner and duct assembly.
26. Bleed power steering system.
Alternator Rear Brace
