Cutlass Supreme V6-204 3.4L DOHC VIN X SFI (1995)
Power Steering Hose Routing
Remove or Disconnect
1. Place drain pan under pump assembly and gear assembly.
2. Engine mount strut assemblies at engine.
3. Reservoir inlet hose from pump assembly.
4. Tie straps from hose assemblies.
5. Raise and suitably support vehicle.
CAUTION: Failure to disconnect intermediate shaft from rack and pinion stub shaft can result in damage to steering gear and/or
intermediate shaft. This damage can cause loss of steering control which could result in personal injury.
NOTICE: Set steering shaft so block tooth on upper steering shaft is at the 12 o'clock position, wheels on vehicle are straight ahead and set
ignition switch to "LOCK" position. Failure to follow these procedures could result in damage to the coil assembly.
6. Intermediate shaft bolt/screw (pinch bolt), and move plastic cover aside.
7. Rear drivetrain and front suspension bolts/screws. Lower drivetrain and front suspension frame assembly.
8. Exhaust pipe assembly.
9. Exhaust pipe front heat shield and heat shield screws.
10. Power steering gear outlet hose clip.
11. Inlet hose assembly from steering gear assembly.
12. Cooling pipe assembly from steering gear assembly.
13. Power steering gear pipe clip bolts/screws.
14. Power steering fluid cooling pipe clips.
15. Cooling pipe assembly from drivetrain and front suspension frame assembly.
16. Cooling pipe assembly and reservoir inlet hose from vehicle.
17. Cooling hose clamp.
18. Cooling pipe assembly.
Install or Connect
1. Position cooling pipe assembly to reservoir inlet hose until properly seated.
