Cutlass Supreme FWD V6-189 3.1L (1989)
Fig. 4 Bolt Boot & Sleeve Installation
14.
Install sleeves and bolt boots into caliper housing as follows:
a. Lubricate sleeves, bolt boots and caliper mounting bolt holes with silicone based grease.
b. Install one bolt boot into groove in mounting bolt hole of caliper housing.
c. Push sleeve into mounting bolt hole, past inner diameter of bolt boot, and position as shown in view A of Fig. 4.
d. Install second bolt boot in groove at other end of mounting bolt hole as shown in view B of Fig. 4.
e. Push sleeve in opposite direction until grooves of sleeve seat in inner diameter of both bolt boots as shown in view C of Fig. 4.
f.
Repeat steps b through e to install remaining bolt boots and sleeve.
15.
Install caliper as outlined further on.
Caliper Installation