Cutlass Supreme FWD V6-189 3.1L (1989)
92.
Install engine lifting device and remove engine assembly from stand.
93.
Install flywheel. Apply GM thread locker (GM P/N 12345382 or equivalent) to all flywheel bolts and tighten bolts to 70 N-m (52 lb.ft.).
94.
Install engine assembly in vehicle.
95.
Install upper engine/transaxle mounting bolts. Tighten bolts to 75 N-m (55 lb.ft.).
96.
Remove support at transaxle.
97.
Remove engine lifting device.
98.
Raise vehicle.
99.
Install lower engine/transaxle bolts. Tighten bolts to 75 N-m (55 lb.ft.).
100. Install front engine mount nuts at frame. Tighten nuts to 45 N-m (34 lb.ft.).
101. Install transaxle support bracket bolts at transaxle. Tighten rear bolts to 83 N-m (61 lb.ft.) and front bolts to 43 N-m (35 lb.ft.).
102. Install A/C compressor and mounting bolts. Refer to service manual details of installation procedure, section 1B.
103. Install torque converter bolts. Tighten bolts to 60 N-m (44 lb.ft.).
104. Connect lower ground strap at transaxle.
105. Install starter motor.
106. Install flywheel cover. Tighten bolts to 10 N-m (89 lb.in.).
107. Install rear A/C compressor to starter pencil brace. Refer to service manual for details on installation procedure, section 1B.
108. Connect front exhaust pipe at manifold with new seal (P/N 10094825). Tighten bolts to 47 N-m (35 lb.ft.).
109. Install right engine splash shield.
110. Install oil filter.
111. Lower vehicle.
112. Rotate engine to forward position.
113. Connect oxygen sensor electrical connector.
114. Connect vacuum modulator line at transaxle.
115. Connect upper electrical grounds at transaxle.
116. Connect fuel lines at rail and bracket.
117. Connect upper engine wiring harness connectors and install tie straps.
118. Install power steering pump mounting bolts. Tighten bolts to 27.5 N-m (20.5 lb.ft.).
119. Install throttle control cable bracket at plenum.
120. Install brake vacuum pipe at plenum and booster.
121. Install throttle control cables at throttle body.
122. Install generator assembly.
123. Install MAP sensor and bracket.
124. Rotate engine to normal position and connect both engine mounts.
