Cutlass Supreme FWD V6-189 3.1L (1989)
CAUTION: LEAF SPRING IS UNDER HIGH TENSION. DO NOT REMOVE BOLTS AS PERSONAL INJURY COULD RESULT.
4.
Pull Insulator bracket from bolts.
5.
Insulator from stabilizer shaft.
INSTALL OR CONNECT
1.
Insulator to stabilizer shaft.
2.
Strut/upper auxiliary spring bracket/stabilizer shaft bracket nuts.
-
Align marks to ensure proper alignment.
Tighten
-
Nuts to 180 N-m (133 lb.ft.)
3.
Lower vehicle.
Rear Rod
REMOVE OR DISCONNECT
Tool Required:
J37956 Auxiliary Spring Compressor
1.
Raise vehicle, refer to General Information (Section 0A).
2.
Tire and wheel assembly, refer to Tires and Wheels (Section 3E).
3.
Auxiliary spring using J37956, refer to "Auxiliary Spring".
4.
Auxiliary spring lower bracket at rod.
5.
Rod nut at crossmember.
6.
Rear toe adjusting cam and push bolt forward enough to provide rod removal clearance.
7.
Rod
INSTALL OR CONNECT
1 .
Rod
2.
Push bolt rearward through rod bushing and Install rear toe adjusting cam.
3.
Rod nut at crossmember, and snug nut only.
-
Do not tighten at this time.
4.
Auxiliary spring lower bracket to rod.
Tighten
-
Nut to 180 N-m (133 lb.ft.)
5.
Auxiliary spring using J37956, refer to "Auxiliary Spring".
6.
Tire and wheel assembly, refer to Tires and Wheels (Section 3E).
7.
Lower vehicle.
Adjust
