Cutlass Supreme FWD V6-189 3.1L (1989)
4. Water deflector by peeling deflector off door inner panel and removing waterproof tape.
INSTALL OR CONNECT
1. Water deflector to door inner panel, making sure that tabs on the bottom of deflector are in slots in bottom of door inner panel.
2. Waterproof tape over slots in bottom of door inner panel where water deflector tabs were installed.
3. Support brackets removed in step 3 of removal procedure.
4. Safety belt retractors.
5. Waterproof tape to any damaged areas of deflector.
6. Door trim panel.
Window Regulator
WINDOW REGULATOR
Door Window Removal
^
Coupe and sedan front doors use a single lift arm regulator. The sedan rear doors use a tape drive regulator. The following provides the procedures
required for removal and replacement of both power and manual window regulators.
REMOVE OR DISCONNECT
IMPORTANT
^
Tape window to the full-up position.
1. Door trim panel.
2. Water deflector.
3. Rivets using 6.3 mm (1/4 inch) drill bit.
4. Regulator by disengaging regulator arm from sash channel.
5. Electrical connector to motor (power window systems) and remove regulator through door inner access hole.
INSTALL OR CONNECT
1. Regulator through access hole and attach regulator arm to sash channel.
2. Electrical connector to motor (power window system).
3. Rivets using 1/4 inch x 1/2 inch peel type rivets.
4. Water deflector.
5. Door trim panel.
Window Regulator Motor
