Delta 88 V6-3800 3.8L (1988)
FIGURE 3
3.
Locate the point where the left side support leg of the cage connects to the pushrod pass through surface. Apply a small force between this point
and the steering column support bracket to move the cage assembly to the right, toward center of vehicle (Figure 3, Point A). Do not apply force
on the cage leg (Figure 3, Point B). Move the cage so that approximately 2 mm of clearance is available between the cage and retainer. Use a flat
blade tool at least one half inch wide to move the cage.
4.
Verify visually that the interference condition is no longer present by again pulling the boot to the side. Verify that no bending of the support leg
of the bracket occurred. Verify that the squeak condition is no longer present.
5.
Verify that brake pedal travel is not restricted or impaired. Pull back on the brake pedal to adjust the stop lamp switch. Then depress the pedal to
apply the brakes and observe the brake pedal to verify that pedal travel is not restricted. Again verify proper stop lamp switch and cruise switch
