Delta 88 V6-3800 3.8L (1988)
FIGURE 1
1.
Loosen door latch retaining screws (1); do not completely remove them (see Figure 1).
2.
Rotate fork bolt (2) upward.
3.
Place screwdriver between door latch and door sheet metal and apply downward pressure to prevent plunger body from turning.
4.
Remove retaining nut (3) with Tool J 36877.
5.
With screwdriver still in place, install new nut (3), Part Number 20654113, and torque to 8 - 10 N-m (6 - 7 ft.lbs.).
6.
Tighten door latch retaining screws (1) to 6 - 7.5 N-m (4.5 - 5.5 ft.lbs.).
7.
Rotate fork bolt (2) downward.
8.
Inspect operation by repeating Steps 1 and 2 of inspection procedure. If plunger does not return and comfort lock does not release; continue to
plunger and cable assembly replacement.
FIGURE 3
PLUNGER AND CABLE ASSEMBLY REPLACEMENT
1.
With door glass in up position, remove the door trim (See Front Door Trim Panel, Section 5 of 1987 Body Service Manual).
2.
Remove plunger cable assembly (1) at splitter box (3) lower cable (see Figure 3).
3.
a. Inspect by activating plunger. If it does not travel inward to a flush condition or does not return freely, plunger cable assembly must be replaced.
Proceed to Step 4.
