Delta 88 V6-3800 3.8L (1988)
DOOR INNER PANEL WATER DEFLECTOR
^
A waterproof clear plastic deflector is used to seal the door inner panel and prevent entry of water into the body. The deflector is secured to the
door inner panel with pressure sensitive tape located on the outboard surface of the deflector. This allows the deflector to be peeled back as needed
to service door components.
REMOVE OR DISCONNECT
1. Door trim panel
2. Armrest support brackets and any other items (if installed over water deflector) seat belt retractor require removal.
3. Water deflector by peeling deflector off door inner panel.
INSTALL OR CONNECT
1. Water deflector to door inner panel, making sure tabs of deflector are installed in door inner panel drain slots.
2. Armrest support brackets and any other items (if installed over water deflector).
3. Door trim panel.
Window Regulator - Front Door
WINDOW REGULATOR REPLACEMENT
Regulator Rivet Locations
REMOVE OR DISCONNECT
1. Trim panel.
2. Speaker if present.
3. Water deflector (see procedure).
4. Any items attached to door inner panel which are blocking access hole for regulator removal from door.
5. Regulator to door inner panel rivets (1), five required, using a 6.3 mm (1/4") drill bit.
6. Lock actuator to door inner panel rivets (2), two required, using a 6.3 mm (1/4") drill bit (sedan styles).
7. Actuator to outside of door inner panel.
8. Block or tape glass in full-up position to door frame.
9. Wire harness from regulator motor
10. Guide and block assembly on regulator from glass lower sash by rotating regulator rearward 180 degrees.
11. Regulator from door through access hole.
INSTALL OR CONNECT
1. Regulator to door inner panel through access hole.
2. Guide and block assembly to glass lower sash.
3. Wire harness to regulator motor.
4. Door lock actuator to door inner panel using 1/4" peel type rivets.
5. Regulator to door inner panel using 1/4" peel type rivets. Inspect regulator for proper operation.
