Firenza L4-112 1.8L VIN 0 TBI (1982)
4.
After engine has been run, recheck tension with gauge on belt, to within prescribed band on gauge.
^
If reset of tension is required, it is imperative that gauge be removed from belt before the readjustment is performed.
^
If gauge is left on belt during the reset of tension, the reading will be incorrect. In other words, the gauge must not be installed during
tensioning due to a possible over-tensioning effect.
^
The timing mark on the camshaft gear and carrier must be aligned during the final tension recheck or reset.
5.
Tighten water pump bolts. Torque to 24 N-m (18 ft.lbs.).
6.
Install probe holder.
7.
Install timing cover and two upper bolts (not tightened).
8.
Raise vehicle.
9.
Install crankshaft pulley.
10.
Install air conditioning belt (if equipped). Set belt tension to 350 N (75 lbs.).
11.
Install two (2) lower timing cover bolts and tighten.
12.
Install inner splash shield.
13.
Install right front wheel. Torque nuts to 140 N-m (100 ft.lbs.).
14.
Lower vehicle.
15.
Position and connect canister purge hose.
16.
Install two (2) upper timing cover bolts.
17.
Install power steering belt (if equipped). Set belt tension to 450 N (100 lbs.) minimum.
18.
Tighten generator pivot bolts to 33 N-m (24 ft.lbs.).
PART III - INSTALLATION OF CAMPAIGN IDENTIFICATION LABEL
Each vehicle modified in accordance with the instructions outlined in this service procedure will require a campaign identification label. Each label
provides a space to include the campaign number, the five-digit dealer code of the dealer performing the campaign service, and the date vehicle was
campaigned. This information may be inserted with a typewriter or ballpoint pen. Install the label on the fan shroud where it is readily visible.
Parts, Warranty & Letter Information
PARTS INFORMATION
Timing belt (part number 90122429) is to be obtained from WDDGM.
To ensure this part will be obtained as soon as possible, it should be ordered from WDDGM on a C.I.O. order with no special instruction code, but order
on an advise code (2).
A replaced timing belt is to be retained for disposition by zone personnel.
WARRANTY INFORMATION
FAILURE
LABOR
LABOR
OPERATION
CODE
OPERATION
HOURS
Replace Timing Belt
96
V1890
1.0 hrs.
With A/C or P/S
96
V1891
1.2 hrs.
With A/C & P/S
96
V1892
1.4 hrs.
.1 hour for clerical administration may be added to the above operations.
