Firenza L4-112 1.8L VIN 0 TBI (1982)
ASSEMBLE
1. Place throttle body assembly on a suitable holding fixture to avoid damage to the throttle valve.
2. Install new gasket and IAC in throttle body. Refer to "Idle Air Control Assembly, Replace." Do not over tighten to prevent damage to valve.
3. Install TPS actuator lever by aligning flats on lever with flats on end of shaft. Install retaining screw and tighten securely. Use thread locking
compound when installing TPS.
4. Install new fuel meter body insulator gasket on throttle body assembly. Ensure gasket is installed correctly when cut out portions match
throttle body assembly.
5. Install fuel meter body on insulator gasket. Apply a thread locking compound to threads of fuel meter body attaching screws. Torque attaching
screws and lockwashers to 35 in. lbs.
6. Place new gaskets in fuel meter body and install fuel inlet and outlet nuts. Torque nuts to 21 ft. lbs.
7. Install fuel injector.
8. Install fuel pressure regulator dust seal into recess on fuel meter body, Fig. 167.
9. Install new gasket, sealing fuel return passage, on fuel meter cover, Fig. 175.
10. Install new fuel meter cover gasket on fuel meter body.
11. Install fuel meter cover, ensure pressure regulator dust seal and cover gaskets are properly positioned. Apply a thread locking compound to threads
on the fuel meter cover attaching screws. Install fuel meter cover attaching screws and lockwashers. Torque to 28 in. lbs. The two shorter screws
go next to the fuel injector.
