oldsmobile Workshop Repair Guides

Oldsmobile Workshop Service and Repair Manuals

Campaign - Cold Start-ability Adjustment|Page 2772 > < Campaign - Cold Start-ability Adjustment|Page 2770
Page 3
background image

Your cooperation in completing this campaign as soon as possible will be greatly appreciated.
On vehicles repaired per the cold startability bulletins (Dealer Technical Bulletins 84-T-20 and 84-T-20A), normal check engine light procedures for
trouble code 42 will no longer apply. This trouble code can no longer be set on these vehicles. On vehicles exhibiting the driveability conditions listed
below, refer to the following supplemental diagnostic information.

If the supplemental diagnostic procedures do not repair the condition, then the cold start repairs are not the cause and normal diagnostic procedures
should be used.

Diagnostic Supplement - 1983-84 Vehicles Repaired Per Cold Startability Bulletins.

SET TIMING CONNECTOR LOCATION

CONDITION

Engine Cranks But Will Not Run or Engine

Disconnect "Set Timing" connector. See

Starts But Immediately Stops.

illustration for "Set Timing" connector
location. If engine starts see Code Chart 42 for open or short to ground in EST CKT
423.

Hard Start -10~ F (-23~ C). May Hear Metallic

Check:

"Knock" during crank.

-

Open circuit 906

-

Open relay ground

-

Faulty relay (will not close during crank)

Campaign - Cold Start-ability Adjustment|Page 2772 > < Campaign - Cold Start-ability Adjustment|Page 2770