Firenza L4-121 2.0L VIN K TBI (1987)
FIGURE 2
2.
Mark the location of the new velcro strips on the headliner and remove the grey foam from those areas to obtain a smooth surface. Figure 2.
3.
Attach female velcro strips to the headliner as follows:
A.
Apply 454 adhesive (minimum amount) to the entire back side of the new center velcro strips and install on the front and rear of the headliner
in the prepared smooth locations.
B.
Apply 414 adhesive to the four remaining female velcro strips (minimum amount) and install on the other prepared smooth areas of the
headliner. Figure 2.
C.
Allow these to stand for approximately 10 minutes.
