Firenza L4-121 2.0L VIN K TBI (1987)
Fig. 19 Sectional view of oil pump assembly
DISASSEMBLE
1.
Remove four pump cover to body attaching bolts, then remove cover, idler and drive gears and shaft, Fig. 19. Place align mark on oil pump
drive and idler gear teeth so they can be installed in the same position.
2.
Remove pressure regulator valve retaining pin, spring and the valve from pump body.
INSPECTION
Inspect pump components and should any of the following conditions exist, the oil pump assembly should be replaced.
1.
Inspect pump body, gears and cover for cracks or excessive wear.
2.
Check drive gear shaft for looseness in housing.
3.
Check inside of pump cover for wear that would allow oil to leak past ends of gears.
4.
Check oil pickup screen assembly for damage to screen or pickup tube.
5.
Check pressure regulator valve for fit in pump body.
Fig. 19 Sectional view of oil pump assembly
