Firenza L4-121 2.0L VIN K TBI (1987)
FIGURE 1(COIL WIRE SHIELD NOT SHOWN)
SERVICE PROCEDURE
1.
Install fender blanket on left fender and disconnect negative battery cable.
2.
Remove air cleaner and inspect for pencil brace (see Figure 1). If pencil brace is NOT present, follow instructions for "PENCIL BRACE AND
COIL WIRE SHIELD REQUIRED" otherwise follow instructions for "COIL SHIELD ONLY REQUIRED" as described below.
PENCIL BRACE AND COIL WIRE SHIELD REQUIRED
3.
Disconnect electrical wiring from coil.
4.
Remove upper existing coil bracket bolt (20 mm long) and loosen lower existing coil bolts.
5.
Remove two (2) lift bracket nuts and discard.