Firenza V6-173 2.8L (1986)
Valve Body: All Technical Service Bulletins
A/T - All Control Valve Assemblies Cleaning/Servicing
SUBJECT
ALL THM TRANSMISSION/TRANSAXLE
NUMBER: 86-T-23
ASSEMBLIES-CONTROL VALVE ASSEMBLY CLEANING/SERVICING PROCEDURES
DATE:
March 24, 1986
MODELS/YEARS
ALL MODELS
SECTION: 7A
GENERAL CONTROL VALVE ASSEMBLY CLEANING/SERVICING PROCEDURE
The following information is provided as a recommended procedure for cleaning/servicing all automatic transmission/transaxle control valve assemblies
when:
^
Diagnosis indicates a stuck or sticking valve(s).
^
A transmission/transaxle pump or torque converter malfunction requires a complete unit overhaul.
EQUIPMENT AND WORK AREA
WORKBENCH
^
Must be clean and free of any foreign material (dirt, grease or other contaminants).
^
Work area should be large enough to allow for the disassembly of the control valve assembly and the layout of each valve train.
TOOLS
^
Should be cleaned with solvent before and during the disassembly procedures to ensure they are free of any grease or dirt that may
contaminate the control valve assembly.
SOLVENT AND PARTS CLEANING TANK
^
Must be clean and free of contamination from engine or other components.
^
Must be clean and filtered if solvent is recirculated.
SAFETY EQUIPMENT
^
Safety glasses and rubber gloves are the minimum requirements to ensure personal safety.
CLEANING PROCEDURES
Tools Required
-
Appropriate Service Manual
-
Awl
-
Micro fine lapping compound
-
Tapered No. 49 drill bit
-
Pencil type magnet
-
Small flat blade screwdriver
-
Small non-abrasive parts cleaning brush
Cleaning And Disassembly
1.
Remove the control valve assembly from the transmission/transaxle following the procedures contained in the appropriate Service Manual.
2.
Inspect the attaching bolts and bolt holes. Remove metal chips or foreign material that may be present.
3.
Place the control valve assembly in a clean tank and with clean solvent thoroughly wash the the entire outer surfaces of the valve body.
4.
Remove the control valve assembly from the solvent and dry it using compressed air.
