Intrigue V6-3.8L VIN K (1998)
Brake Caliper: Service and Repair
Brake Caliper Replacement - Front
REMOVAL PROCEDURE
CAUTION: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in
personal injury.
1. Remove two-thirds of the brake fluid from the master cylinder.
2. Raise and suitably support the vehicle.
3. Remove the tire and wheel. Refer to Wheel Removal in Tires and Wheels.
4. Install two nuts to retain the rotor to the hub.
5. Install a large C-clamp (2) over the top of the brake caliper and against the back of the outboard brake pad.
6. Tighten the C-clamp until the caliper piston is pushed into the caliper bore enough to slide the caliper off the rotor.
7. If the brake caliper is going to be removed from the vehicle for unit repair (overhaul) or replacement, go to Step 8 If the brake caliper is not being
replaced or overhauled, go to Step 13.
