Intrigue V6-3.8L VIN K (1998)
12. Remove the bleeder valve cap (1) and the bleeder valve (2) from the brake caliper housing (3).
13. Clean all the parts with clean, denatured alcohol.
14. Dry all the parts with filtered, non-lubricated compressed air.
15. Use filtered, non-lubricated compressed air in order to blow out all of the passages in the caliper housing and the bleeder valve.
ASSEMBLY PROCEDURE
-
Tools Required
-
J 36349 Dust Boot Seal Installer
NOTICE: Refer to Fastener Notice in Service Precautions.
1. Install the bleeder valve (2) and the bleeder valve cap (1) to the caliper housing (3).
-
Tighten the bleeder valve (2) to 13 Nm (115 inch lbs.).
2. Install a new lubricated piston seal (4) to the caliper bore grooves. Ensure that the piston seal is not twisted.
