Intrigue V6-3.8L VIN K (1998)
10. Inspect and replace any brake caliper bolt pin boots (3) that exhibit any of the following conditions:
-
Cuts
-
Tears
-
Deterioration
11. Inspect the brake caliper bolts for corrosion or damage. Replace any corroded brake caliper bolts. Do not attempt to polish away the corrosion.
12. Remove the bleeder valve cap (17) and the bleeder valve (16) from the brake caliper housing (15).
13. Clean all the parts with clean, denatured alcohol.
14. Dry all the parts with filtered, non-lubricated compressed air.
15. Use filtered, non-lubricated compressed air in order to blow out all of the passages in the caliper housing and the bleeder valve.
ASSEMBLY PROCEDURE
-
Tools Required
-
J 36349 Dust Boot Seal Installer
NOTICE: Refer to Fastener Notice in Service Precautions.