Intrigue V6-3.8L VIN K (1998)
48. Install the clear plastic bleeder hose to the ABS modulator REAR bleeder valve (1).
49. Submerge the opposite end of the clear plastic bleeder hose in a clean container partially filled with clean brake fluid.
50. Open the ABS modulator bleeder valve.
51. Press and hold the brake pedal approximately 75 percent of a full stroke.
52. Close the ABS modulator bleeder valve.
53. Release the brake pedal.
54. Repeat Steps until air bubbles are no longer detected in the brake fluid.
55. Remove the clear plastic bleeder hose from the ABS modulator bleeder valve.
-
Tighten the previously bled ABS modulator bleeder valve to 9 Nm (80 inch lbs.).
56. Install the clear plastic bleeder hose to the ABS modulator FRONT bleeder valve (2).
57. Repeat Steps from rear bleeder valve.
IMPORTANT: Use a shop cloth in order to catch escaping brake fluid.
58. Open the ABS modulator brake pipe fitting (1).
