Intrigue V6-3.8L VIN K (1998)
2. Install the caliper bracket bolts.
-
Tighten the brake caliper bracket bolts to 125 Nm (92 ft. lbs.).
3. Install the brake pad retainers to the brake caliper bracket.
4. Apply a thin coat of silicone grease (GM P/N 18010909 or equivalent) to the brake pad retainers where the brake pads contact the brake pad
retainers.
5. Lubricate the brake caliper bolt bushings (4) with silicone grease (GM P/N 18010909 or equivalent).
6. Install the brake caliper bolt bushings (4) to the brake caliper bracket.
7. Lubricate the brake caliper bolt boots (3) with silicone grease (GM P/N 18010909 or equivalent).
8. Install the brake caliper bolt boots to the brake caliper bracket.
9. Install the brake caliper;. Refer to Brake Caliper Replacement- Rear.
Brake Caliper Replacement - Front
REMOVAL PROCEDURE
CAUTION: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in
personal injury.
1. Remove two-thirds of the brake fluid from the master cylinder.
2. Raise and suitably support the vehicle.
3. Remove the tire and wheel. Refer to Wheel Removal in Tires and Wheels.
4. Install two nuts to retain the rotor to the hub.
