Intrigue V6-3.8L VIN K (1998)
8. Assemble the brake hose bolt (1) and the NEW copper brake hose gaskets (3) to the rake hose (2).
9. Install the brake hose bolt to the brake caliper. the brake hose bolt to 54 Nm (40 ft. lbs.).
10. Remove the nuts securing the rotor to the hub.
11. Install the tire and wheel. Refer to Wheel Installation in Tires and Wheels.
12. Lower the vehicle.
13. Fill the master cylinder to the proper level with clean brake fluid. Refer to "Master Cylinder Reservoir Filling" in Hydraulic Brakes.
14. Bleed the brake system if the brake hose was disconnected from the brake caliper. Refer to Hydraulic Brake System Bleeding in Brake Bleeding.
CAUTION: Do not move the vehicle until a firm brake pedal is obtained. Air in the brake system can cause the loss of brakes with
possible personal injury.
15. Pump the brake pedal (3/4 of a full stroke) as many times as necessary to obtain a firm brake pedal.
16. Apply approximately 778 Nm (175 ft. lbs.) of force to the brake pedal for ten seconds.
17. Inspect the brake caliper and hydraulic brake system for brake fluid leaks.
Brake Caliper Replacement - Rear
