Intrigue V6-3.8L VIN K (1998)
3. Install the lubricated boot (1) onto the brake caliper piston (2).
4. Lubricate the brake caliper piston (2) with clean brake fluid.
5. Install the brake caliper piston and the brake caliper piston boot into the bore of the caliper. Push the brake caliper piston to the bottom of the bore.
6. Seat the caliper boot in the caliper housing (1) counterbore using the J 36349 Dust Boot Seal Installer.
7. Install the caliper. Refer to Brake Caliper Replacement- Front.
Brake Caliper Overhaul - Rear
Important:
-
Replace all the components included in the repair kit.
-
Lubricate all of the rubber parts with clean brake fluid in order to ease assembly.
-
Perform this overhaul procedure on a clean bench.
DISASSEMBLY PROCEDURE
1. Remove the brake caliper. Refer to Brake Caliper Replacement- Rear.
CAUTION: Do not place fingers in front of the caliper piston(s) in an attempt to catch or protect it when applying compressed air. The
piston(s) can fly out with force and could result in serious bodily injury.
NOTICE: Use clean cloths to pad interior of caliper housing during piston removal. Use just enough air to ease the pistons out of the bores. If the
pistons are blown out, even with the padding provided, it may be damaged.
