Intrigue V6-3.8L VIN K (1998)
19. If replacing the engine front cover, remove the oil pump cover and gear set from the engine front cover.
20. Inspect the oil pump cover and gear set.
21. If replacing the engine front cover, remove the camshaft position sensor from the engine front cover.
22. Inspect the timing chain for overall in and out movement. Maximum movement is 25.4 mm (1 inch).
23. Inspect the sprockets for wear.
24. Clean the mating surfaces of the front cover and cylinder block.
25. Clean the sealing surfaces with degreaser.
INSTALLATION PROCEDURE
^
Tools Required
-
J 36660 Electronic Torque Angle Meter
-
J 37096 Flywheel Holder
1. If you are installing a new engine front cover, install the camshaft position sensor to the engine front cover.
^
Tighten the camshaft position sensor bolts to 10 Nm (89 inch lbs.).
