Intrigue V6-3.8L VIN K (1998)
4. Install the upper right (rear) exhaust manifold heat shield.
5. Install the new right (rear) exhaust manifold gasket.
6. Install the right (rear) exhaust manifold.
7. Install the right (rear) exhaust manifold stud behind the oxygen sensor.
8. Connect the oxygen sensor electrical connector.
9. Return the engine to the original position.
10. Raise and suitably support the vehicle.
11. Install the remaining exhaust manifold studs and nuts.
^
Tighten the right (rear) exhaust manifold studs and nuts to 30 Nm (22 ft. lbs.).
12. Install the fuel injector sight shield bracket.
13. Install the fuel injector sight shield bracket nuts.
^
Tighten the fuel injector sight shield bracket nuts to 30 Nm (22 ft. lbs.).
