Intrigue V6-3.8L VIN K (1998)
14. Install the right (rear) engine lift bracket.
15. Install the right (rear) engine lift bracket bolt and nut.
^
Tighten the right (rear) engine lift bracket bolt and nut to 30 Nm (22 ft. lbs.).
16. Install the right (rear) spark plug wires.
17. Install the wiring harness and the heater hose retaining clips to the fuel injector sight shield bracket.
18. Connect the three way catalytic converter pipe to the right (rear) exhaust manifold.
19. Install the EGR adapter pipe to the right (rear) exhaust manifold.
IMPORTANT: Whenever the EGR pipe is removed from the right (rear) exhaust manifold, the outlet pipe should be inspected for leaks during
installation. If leaks are present, replace the EGR adapter.
20. Lower the vehicle.
21. Install the exhaust crossover pipe to the right (rear) exhaust manifold.
22. Install the fuel injector sight shield. Refer to Engine Cover Replacement See: Engine/Service and Repair.
23. Connect the battery ground (negative) cable.
