Intrigue V6-3.8L VIN K (1998)
Air Door Actuator / Motor: Technical Service Bulletins
Defroster Actuator - Revised Replacement Procedure
File In Section: 01 - HVAC
Bulletin No.: 02-01-38-001
Date: February, 2002
SERVICE MANUAL UPDATE
Subject:
Revised Defroster Actuator Replacement Procedure
Models:
1998-2002 Oldsmobile Intrigue
This bulletin is being issued to revise the Defroster Actuator Replacement procedure in the HVAC-Manual and HVAC-Automatic sub-sections of the
Service Manual. Please replace the current information in the Service Manual with the following information.
The following information has been updated within SI2000. If you are using a paper version of this Service Manual, please make a reference to this
bulletin on the affected page.
Removal Procedure
1.
Remove the right instrument panel (IP) insulator panel. Refer to Closeout/Insulator Panel Replacement Right in Instrument Panel, Gages and
Console.
2.
Remove the IP compartment. Refer to Compartment Replacement IP in Instrument Panel, Gages and Console.
3.
Remove the screws and push pin from the rear IP compartment cover.
4.
Remove the rear IP compartment cover from the IP.
5.
Remove the two bolts from the relay pack.
6.
Position the relay pack aside.
7.
Disconnect the two vacuum lines from the defroster actuator (3).
8.
Disconnect the orange vacuum line from the recirculation actuator and install a hand vacuum pump (2).
9.
Remove the defroster actuator from its attachment to the HVAC module case.
