Intrigue V6-3.8L VIN K (1998)
Compressor Shaft Seal: Service and Repair
Remove
Tools Required
-
J 39400-A Leak Detector
-
J 5403 Snap Ring Pliers
-
J23128-A Seal Seat Installer And Remover
-
J 39400-A Leak Detector
-
J 39500 R-134a Air Conditioning Recovery Recycling And Recharging System
Important: Do not change a shaft seal because of small amounts of oil found on an adjacent surface. The seal allows some oil to pass for lubrication
purposes. Change the shaft seal when the following conditions exist:
-
A large amount of sprayed oil is found.
-
Actual refrigerant leak is found, using a J 39400-A or equivalent.
1. Recover the refrigerant using the J 39500.
2. Loosen the compressor in the mounting brackets. Reposition the compressor.
3. Remove the clutch plate and hub assembly.
4. Remove the shaft seal retaining ring using the J5403.
5. In order to prevent dirt or foreign material from damaging the compressor, thoroughly clean the following parts:
-
The inside of the compressor neck area surrounding the shaft
-
The exposed portion of the seal
-
The compressor shaft
-
The O-ring groove
