Intrigue V6-3.8L VIN K (1998)
2. Install a clear plastic bleeder hose to the ABS modulator REAR bleeder valve (1).
3. Submerge the opposite end of the clear plastic bleeder hose in a clean container partially filled with clean brake fluid.
4. Open the ABS modulator bleeder valve.
5. Press and hold the brake pedal approximately 75 percent of a full stroke.
6. Close the ABS modulator bleeder valve.
7. Release the brake pedal.
8. Repeat Steps 4 through 7 until brake fluid begins to flow.
9. Remove the clear plastic bleeder hose from the ABS modulator bleeder valve.
10. Install the clear plastic bleeder hose to the ABS modulator FRONT bleeder valve (2).
11. Repeat Steps 4 through 9.
The ABS modulator is now PRIMED ONLY.
12. Raise and suitably support the vehicle.
13. Install the clear plastic bleeder hose to the RIGHT REAR bleeder valve.
14. Submerge the opposite end of the clear plastic bleeder hose in a clean container partially filled with clean brake fluid.
15. Open the bleeder valve.
16. Press and hold the brake pedal approximately 75 percent of a full stroke.
17. Close the bleeder valve.
18. Release the brake pedal.
19. Repeat Steps until air bubbles are no longer detected in the brake fluid.
-
Tighten the wheel cylinder bleeder valve to 11 Nm (97 inch lbs.).
