oldsmobile Workshop Repair Guides

Oldsmobile Workshop Service and Repair Manuals

BCM - New Replacement/Service Procedures|Page 4694 > < BCM - New Replacement/Service Procedures|Page 4692
Page 4
background image

14.

Answer the question prompted by the scan tool, then select RE-LEARN.

15.

The Powertrain Control Module (PCM) and the BCM will be prepared for re-learn.

16.

A security timer will be on for approximately 10 minutes. During the 10 minute wait period, the scan tool must remain connected to the vehicle.

17.

When the PCM and BCM are prepared to re-learn, turn the ignition switch off.

18.

Turn the ignition switch to the start position.

19.

The engine should now start when the ignition switch is turned to the start position.

20.

Disconnect the scan tool from the DLC.

Theft Deterrent RE-Learn Using T-50 or T-60

1.

Enter the T-50 or T-60 Service Programming System (SPS).

2.

Select TERMINAL TO VEHICLE PROGRAMMING.

3.

Select DONE and follow the instructions on the VEHICLE SETUP screen.

4.

Select THEFT MODULE RE-LEARN.

5.

Follow the instructions on the remaining screens:

^

The PCM and BCM will be prepared for re-learn.

^

A security timer will be on for approximately 10 minutes. During the 10 minute wait period, the T-50 or T-60 terminal must remain connected
to the vehicle.

^

When the PCM and BCM are prepared to re-learn, turn the ignition switch off, then to the start position. The engine should now start.

Theft Deterrent RE-Learn Without Scan Tool or Techline Equip.

This procedure takes approximately 30 minutes. Make sure the battery is fully charged before proceeding. Refer to the Battery section for more
information.

1.

Turn the ignition switch off.

2.

Turn the ignition switch all the way from the off to the start position, then leave it in the on position.

Important:

The engine will not crank.

3.

The SECURITY indicator lamp in the instrument cluster will turn on and stay on for at least 10 minutes.

4.

Turn the ignition switch off for five seconds.

5.

Repeat steps 2, 3, and 4 again for a second time.

6.

Repeat steps 2, 3, and 4 again for a third time.

7.

Turn the ignition switch all the way to the start position. The engine should now start.

8.

Check for BCM Diagnostic Trouble Codes (DTCs).

BCM - New Replacement/Service Procedures|Page 4694 > < BCM - New Replacement/Service Procedures|Page 4692