oldsmobile Workshop Repair Guides

Oldsmobile Workshop Service and Repair Manuals

Knock Sensor System|Page 5738 > < Diagram Information and Instructions|Page 5735
Page 1
background image

Knock Sensor: Description and Operation
Knock Sensor System

Purpose

Varying octane levels in today's gasoline may cause detonation (spark knocking) in some engines. Detonation is caused by an uncontrolled explosion
(burn) in the combustion chamber. This uncontrolled explosion could produce a flame front opposite to the normal flame front produced by the spark
plug. The rattling sound, normally associated with detonation, is the result of two or more opposing flame fronts colliding within the combustion
chamber. Though light detonation is sometimes considered normal, heavy detonation could result in engine damage. To control spark knock, a knock
sensor (KS) system is used. If engine detonation occurs, the KS system retards the spark timing. The KS system allows the engine to use maximum spark
advance for optimal driveability and fuel economy.

Operation

The knock sensors, located in the engine block near the cylinders, detect abnormal vibration (spark knocking) in the engine. The knock sensors produce
an AC signal under all engine operating conditions. Integrated diagnostic circuitry allows the PCM to detect engine detonation and diagnose the sensors
and related wiring. If engine detonation occurs, the PCM retards Ignition Control (IC) spark timing relative to the amplitude and frequency of the KS
signal being received.
The PCM contains integrated knock sensor (KS) diagnostic circuitry. During operation, the PCM calculates an average voltage of each knock sensor's
signal and performs instantaneous signal voltage readings. The PCM uses the instantaneous signal voltage readings to determine the state of the knock
sensor circuitry. If the knock sensor system is operating normally, the PCM monitors instantaneous signal voltage readings varying outside a voltage
range above and below the calculated average voltage (refer to the normal knock sensor figure).

If PCM detects a signal voltage within the calculated average voltage range, DTC P0327 or P0332 will set (refer to the abnormal knock sensor figure).

Normal Knock Sensor Signal

Normal Knock Sensor Signal

Knock Sensor System|Page 5738 > < Diagram Information and Instructions|Page 5735