Intrigue V6-3.8L VIN K (1998)
Notice:
^
Secure the fuel pipes to the frame in order to prevent chafing. Maintain a minimum of 13 mm (1/2 inch) clearance around a pipe in order to
prevent contact and chafing. Maintain a minimum of 19 mm (3/4 inch) around any moving part.
^
Do not allow the fuel pipes to come into contact with the fuel tank or underbody.
1. Install the new fuel feed, fuel return, and EVAP pipes and the fuel and EVAP pipe attaching hardware as noted during removal.
Important: If fuel line bundle attaching hardware is damaged or broken replace it.
2. Inspect and make sure all of the fuel pipe bundle clips, and fasteners are properly installed.
3. Remove the caps from the in-pipe fuel filter pipe, the fuel feed pipe, and the fuel return pipe.
4. Connect the fuel return pipe quick-connect fitting in front of the fuel tank. Refer to Fuel Line Coupler Service (Metal Collar).
Notice: Refer to Fastener Notice in Cautions and Notices.
5. Connect the fuel feed pipe threaded fitting at the outlet of the in pipe fuel filter.
-
Tighten The in-pipe fuel filter fitting to 30 N.m (22 lb ft).
6. Inspect and make sure all of the fuel pipe bundle clips and fasteners are properly installed.
7. Lower the vehicle.
8. Connect the fuel feed (1), and fuel return pipe (2) quick-connect fittings in the engine compartment. Refer to Fuel Line Coupler Service (Metal
Collar).
9. Add fuel and tighten the fuel tank filler pipe cap.
Caution: Refer to Battery Disconnect Caution in Cautions and Notices.
