Intrigue V6-3.8L VIN K (1998)
8. Note the position of the fuel, and EVAP pipes and the fuel and EVAP pipe attaching hardware for installation.
Installation Procedure
WARNING: In order to Reduce the Risk of Fire and Personal Injury: If nylon fuel pipes are nicked5 scratched or damaged during installation,
they must be replaced.
Notice: Always re-attach the fuel lines and fuel filter with all original type fasteners and hardware. Do not repair sections of fuel pipes.
Notice:
^
Secure the fuel pipes to the frame in order to prevent chafing. Maintain a minimum of 13 mm (1/2 inch) clearance around a pipe in order to
prevent contact and chafing. Maintain a minimum of 19 mm (3/4 inch) around any moving part.
^
Do not allow the fuel pipes to come into contact with the fuel tank or underbody.
1. Install the new fuel feed, fuel return, and EVAP pipes and the fuel and EVAP pipe attaching hardware as noted during removal.
2. Remove the caps from the in-pipe fuel filter pipes and the fuel sender fuel pipes.
3. Connect the fuel feed, fuel return, and EVAP pipe quick-connect fittings at the fuel sender assembly. Refer to Fuel Line Coupler Service (Metal
Collar).
4. Inspect and make sure all of the fuel pipe bundle clips, and fasteners are properly installed.
5. Install the fuel tank.
6. Lower the vehicle.
7. Add fuel and reinstall the fuel tank filler pipe cap.
Caution: Refer to Battery Disconnect Caution in Cautions and Notices.
8. Connect the negative battery cable.
