Intrigue V6-3.8L VIN K (1998)
8. Inspect and make sure filler hose (4) is fully seated on fuel tank port, and fuel filler pipe (2).
9. Make sure clamp (1) is properly located on tank port between the feed (5) and tank (3).
-
Tighten the fuel tank filler hose clamps to 2.5 N.m (22 lb in).
10. Lower the vehicle.
Caution: Refer to Battery Disconnect Caution in Cautions and Notices.
11. Connect the negative battery cable.
12. Inspect for leaks.
12.1. Turn the ignition switch ON for 2 seconds.
12.2. Turn the ignition switch OFF for 10 seconds.
12.3. Turn the ignition switch ON.
12.4. Check for fuel leaks.
13. Reinstall the fuel injection sight shield. Refer to Engine Cover Replacement See: Engine, Cooling and Exhaust/Engine/Service and Repair.
