oldsmobile Workshop Repair Guides

Oldsmobile Workshop Service and Repair Manuals

All Other Service Bulletins for PROM - Programmable Read Only Memory: > < Engine Controls - OBD System Improvement/Correction
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
A/T - Buzz Type Noise On Deceleration

File In Section: 07 - Transmission/Transaxle 

Bulletin No.: 99-O7-3O-008

Date: May, 1999

TECHNICAL

Subject:
Buzz Type Noise On Decel (Reprogram PCM)

Models:
1998 Oldsmobile Intrigue
with 3.8 L V6 Engine (VIN K - RPO L36) 
and Hydra-Matic 4T65-E Transaxle (RPO M15)

Condition

Some owners may comment about a buzz type noise on decel at approximately 17-21 mph (27-34 kph) during the coast-down shift.

Cause

Condition may be due to high line pressure on decel causing pressure regulator valve instability.

Correction

Check cooler line routing for ground-out against body/frame. If no ground-out condition exists, reprogram the Powertrain Control Module with the
appropriate calibration listed below.

Parts information

The calibrations listed are electronic calibrations and are NOT available from GMSPO. Calibrations will be available from Techline starting February
1999, on the 1999 Disk 5 CD ROM.

Warranty Information

For vehicles repaired under warranty, use:

Labor

Operation

Description

Labor Time

Prom -

Use Published

J6355

Reprogramming -

Labor

On Oar

Operation Time

All Other Service Bulletins for PROM - Programmable Read Only Memory: > < Engine Controls - OBD System Improvement/Correction